Oce 3121 Technical & Service Manual page 555

Fitting the fusing film
The film should be fitted with the alignment shaping at the rear
Warning:
(semi-transparent edge).
First slide the semi-transparent edge of the film over the rollers.
Remove the rubber ring, and align the straight edge (the darker edge) of the
1
fusing film with the centre index mark on the heater bar.
Heater bar
Surface of the
film
Refit the fusing film, proceeding in the reverse sequence.
2
Screw
I
Drive roller (bearing, washer, E-ring)
I
Fit the tension arm.
3
E-ring
I
ed.1
Drive
Tension
roller
roller
Alignment lines
on the heater
bar
Darker edge
Semi-transparent edge
Rubber
Fus-
ing ring
heater
Drive roller
Fusing
film
17 Fusing 415