Mitsubishi Electric MELSEC-LD77MS2 User Manual page 1023

(9) Torque limit
The torque limit set by the Simple Motion module is ignored. Set the torque
limit value with the parameter on the AlphaStep/5-phase.
(10) Axis monitor data
(a) "
Motor current value
Md.104
monitor is not used, "
", "
output 1
Md.110
"
Peak torque ratio/Optional data monitor output 3
Md.111
(b) "Zero point pass" (
address): b0) is always OFF.
(c) "Zero speed" (
b3) and "Speed limit" (
address): b4) are always OFF.
(d) "
Semi/Fully closed loop status
Md.113
(e) "
Parameter error No.
Md.107
(f) "In-position" (
b12) is OFF during the axis operation. It is turned ON when the axis
operation is completed.
(11) Amplifier-less operation
The amplifier-less operation cannot be used to the AlphaStep/5-phase axis.
If the amplifier-less operation is used, the AlphaStep/5-phase set axis is
not connected.
(12) In-position range
When the position of the cam axis is restored in synchronous control, a
check is performed by the servo parameter "In-position range" (PA10).
However, because the servo parameter settings are not performed in
AlphaStep/5-phase, the "In-position range" is checked as 100 [PLS].
Appendix - 75
" is always "0". When the optional data
Regenerative load ratio/Optional data monitor
Md.109
Effective load torque/Optional data monitor output 2
Servo status
Md.108
(low-order buffer memory address):
Servo status
Md.108
Servo status
Md.108
" is always "0".
" is always "0".
(high-order buffer memory address):
Servo status
Md.108
Appendices
" are "0".
(low-order buffer memory
(low-order buffer memory
", and