Checking And Adding Wheel Drive Lubricant - MacDon M155 Unloading And Assembly Instructions

19. Check the hydraulic oil level in the reservoir (remove filler
cap / dipstick (A) and add SAE 15W-40 oil if necessary).
Refer to 3.18.4 Checking Hydraulic Oil Level, page
20. Close the platforms.

3.18.12 Checking and Adding Wheel Drive Lubricant

WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
CAUTION
Park on a flat, level surface with the header on the ground, the ground speed lever in N-DETENT position, and the
steering wheel in locked position (centered). Wait for the CDM to beep and display an "In Park" message to confirm the
park brakes have engaged.
1. Park the windrower on level ground.
2. Position windrower so plugs (A) and (B) are horizontally
aligned with the hub center (C).
3. Stop the engine, and remove the key.
4. Remove plug (A) or (B). The lubricant should be visible
through the port or running out slightly.
5. If lubricant needs to be added, remove the second plug (A)
or (B), and add lubricant until lubricant runs out from the
other port (A). For lubricant specifications, refer to the
inside back cover of this book.
6. Reinstall plugs and tighten.
215015
ASSEMBLING THE WINDROWER
77.
Figure 3.118: Filler Cap / Dipstick
Figure 3.119: Drive Wheel Hub
86
A
A
B
C
Revision A