Using The Cli - TP-Link Jetstream T1500G-8T User Manual

Configuring DHCP Filter

4.2.4 Using the CLI

1) Enable DHCPv6 Filter globally and on all pots:
Switch_A#configure
Switch_A(config)#ipv6 dhcp filter
Switch_A(config)#interface range fastEthernet 1/0/1-24
Switch_A(config-if-range)#ip dhcpv6 filter
Switch_A(config)#interface range gigabitEthernet 1/0/25-28
Switch_A(config-if-range)#ip dhcpv6 filter
Switch_A(config-if-range)#exit
2) Create an entry for the legal DHCPv6 server:
Switch_A(config)#ipv6 dhcp filter server permit-entry server-ip 2001::54 interface
fastEthernet 1/0/1
Switch_A(config)#end
Switch_A#copy running-config startup-config
Verify the Configuration
Verify the global DHCPv6 Filter configuration:
Switch_A#show ipv6 dhcp filter
Global Status: Enable
Verify the DHCPv6 Filter configuration on ports:
Switch_A#show ipv6 dhcp filter interface
Interface state
---------
Fa1/0/1
Fa1/0/2
Fa1/0/3
Fa1/0/4
...
Verify the legal DHCPv6 server configuration:
Downloaded from ManualsNet.com
Limit-Rate
------- ----------
Enable Disable
Enable Disable
Enable Disable
Enable Disable
search engine
Dec-rate LAG
-------- ---
Disable N/A
Disable N/A
Disable N/A
Disable N/A
Configuration Examples
User Guide 714