TP-Link Jetstream T1500G-8T User Manual page 806

Step 4
The following example shows how to configure the switch to enable all PoE traps:
Switch#configure
Switch(config)#snmp-server traps power
Switch(config)#end
Switch#copy running-config startup-config
■ Enabling the Link-status Trap for Ports
Step 1
Step 2
Step 3
Step 4
Step 5
The following example shows how to configure the switch to enable link-status trap:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#snmp-server traps link-status
Switch(config-if)#end
Switch#copy running-config startup-config
Downloaded from ManualsNet.com
copy running-config startup-config
Save the settings in the configuration file.
configure
Enter Global Configuration Mode.
interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Configure notification traps on the specified ports.
port/port-list:
The number or the list of the Ethernet ports that you desire to configure
notification traps. To configure multiple ports, enter a list of port numbers separated
by commas, or use a hyphen to indicates a range of port numbers. For example, 1-3, 5
indicates port 1, 2, 3, 5.
snmp-server traps link-status
Enable Link Status Trap for the port. By default, it is enabled. Link Status Trap (including
Linkup Trap and Linkdown Trap) can be triggered when the link status of a port changes,
and the trap is enabled both globally and on the port.
To enable Linkup Trap and Linkdown Trap globally, run the command
snmp [ linkup | linkdown ]
no command.
end
Return to Privileged EXEC Mode.
copy running-config startup-config
Save the settings in the configuration file.
search engine
in Global Configuration Mode. To disable it, run the corresponding
Notification Configurations
snmp-server traps
User Guide 783