Ipv4 Source Guard Configuration; Using The Gui; Adding Ip-Mac Binding Entries; Configuring Ipv4 Source Guard - TP-Link Jetstream T1500G-8T User Manual

Configuring IPv4 IMPB
4

IPv4 Source Guard Configuration

To complete IPv4 Source Guard configuration, follow these steps:
1) Add IP-MAC Binding entries.
2) Configure IPv4 Source Guard.
4.1

Using the GUI

4.1.1 Adding IP-MAC Binding Entries

In IPv4 Source Guard, the switch filters the packets that do not match the rules of IPv4-
MAC Binding Table. So before configuring ARP Detection, you need to complete IP-MAC
Binding configuration. For details, refer to

4.1.2 Configuring IPv4 Source Guard

Choose the menu SECURITY > IPv4 IMPB > IPv4 Source Guard to load the following page.
Figure 4-1 IPv4 Source Guard Config
Downloaded from ManualsNet.com search engine
IPv4 Source Guard Configuration
IP-MAC Binding Configuration.
User Guide 649