TP-Link Jetstream T1500G-8T User Manual page 144

Configuring LAG
Step 9
The following example shows how to specify the system priority of the switch as 2:
Switch#configure
Switch(config)#lacp system-priority 2
Switch(config)#show lacp sys-id
2, 000a.eb13.2397
Switch(config)#end
Switch#copy running-config startup-config
The following example shows how to add ports 1/0/1-4 to LAG 6, set the mode as LACP,
and select the LACPDU sending mode as active:
Switch#configure
Switch(config)#interface range gigabitEthernet 1/0/1-4
Switch(config-if-range)#channel-group 6 mode active
Switch(config-if-range)#show lacp internal
Flags: S - Device is requesting Slow LACPDUs
Channel group 6
Port
Gi1/0/1 SA
Gi1/0/2 SA
Gi1/0/3 SA
Gi1/0/4 SA
Switch(config-if-range)#end
Switch#copy running-config startup-config
Downloaded from ManualsNet.com
copy running-config startup-config
Save the settings in the configuration file.
F - Device is requesting Fast LACPDUs
A - Device is in active mode
P - Device is in passive mode
Flags State LACP Port Priority Admin Key Oper Key Port Number Port State
Up 32768
Down 32768
Down 32768
Down 32768
search engine
0x6 0x4b1
0x6 0
0x6 0
0x6 0
LAG Configuration
0x1 0x7d
0x2 0x45
0x3 0x45
0x4 0x45
User Guide 121