Configuring Hosts To Statically Join A Group - TP-Link Jetstream T1500G-8T User Manual

Configuring Layer 2 Multicast
Switch(config-if-range)#ipv6 mld snooping immediate-leave
Switch(config-if-range)#show ipv6 mld snooping interface gigabitEthernet 1/0/1-3
Port
-----------
Gi1/0/1
Gi1/0/2
Gi1/0/3
Switch(config-if-range)#end
Switch#copy running-config startup-config

3.2.4 Configuring Hosts to Statically Join a Group

Hosts or Layer 2 ports normally join multicast groups dynamically, but you can also
configure hosts to statically join a group.
Follow these steps to configure hosts to statically join a group:
Step 1
Step 2
Step 3
Step 4
Step 5
The following example shows how to configure port 1/0/1-3 in VLAN 2 to statically join the
multicast group FF80::1234:01:
Switch#configure
Switch(config)#ipv6 mld snooping vlan-config 2 static FF80::1234:01 interface
gigabitEthernet 1/0/1-3
Switch(config)#show ipv6 mld snooping groups static
Downloaded from ManualsNet.com
MLD-Snooping
-------------------
enable
enable
enable
configure
Enter global configuration mode.
ipv6 mld snooping vlan-config vlan-id-list static ip interface {fastEthernet port-list |
gigabitEthernet port-list | ten-gigabitEthernet port-list | port-channel lag-list }
vlan-id-list: Specify the ID or the ID list of the VLAN(s).
ip: Specify the IP address of the multicast group that the hosts want to join.
port-list / lag-list: Specify the ports that is connected to the hosts. These ports will become
static member ports of the group.
show ipv6 mld snooping groups static
Show the static MLD Snooping configuration.
end
Return to privileged EXEC mode.
copy running-config startup-config
Save the settings in the configuration file.
search engine
Fast-Leave
--------------
enable
enable
enable
MLD Snooping Configuration
User Guide 243