Configuring System Logs
The following example shows how to configure the local logs on the switch. Save logs of
levels 0 to 5 to the log buffer, and synchronize logs of levels 0 to 2 to the flash every 10
hours:
Switch#configure
Switch(config)#logging buffer
Switch(config)#logging buffer level 5
Switch(config)#logging file flash
Switch(config)#logging file flash frequency periodic 10
Switch(config)#logging file flash level 2
Switch(config)#show logging local-config
Channel
-------
Buffer
Flash
Console
Monitor
Switch(config)#end
Switch#copy running-config startup-config
2.2.2 Configuring the Remote Logs
You can configure up to four hosts to receive the switch's system logs. These hosts are
called Log Servers. The switch will forward the log message to the servers once a log
message is generated. To display the logs, the servers should run a log server software
that complies with the syslog standard.
Follow these steps to set the remote log:
Step 1
Downloaded from
ManualsNet.com
Level
Status
-----
------
5
enable
2
enable
5
enable
5
enable
configure
Enter global configuration mode.
search engine
Sync-Periodic
-------------
Immediately
10 hour(s)
Immediately
Immediately
System Logs Configurations
User Guide
828
Need help?
Do you have a question about the Jetstream T1500G-8T and is the answer not in the manual?