Using The Cli; Viewing The System Summary - TP-Link T1500 Series User Manual

Managing System
Status
2.2

Using the CLI

2.2.1 Viewing the System Summary

On privileged EXEC mode or any other configuration mode, you can use the following
commands to view the system information of the switch:
show interface status [ fastEthernet port | gigabitEthernet port | ten-gigabitEthernet port ]
View status of the interface.
: Enter the number of the Ethernet port.
port
show system-info
View the system information including System Description, Device Name, Device Location, System
Contact, Hardware Version, Firmware Version, System Time, Run Time and so on.
The following example shows how to view the interface status and the system information
of the switch.
Switch#show interface status
Port Status
------- -----------
Gi1/0/1 LinkDown N/A
Gi1/0/2 LinkDown N/A
Gi1/0/3 LinkUp
...
Switch#show system-info
System Description - JetStream 48-Port Gigabit Smart Switch with 4 SFP Slots
System Name
Displays the status of the link-local address. An IPv6 address cannot be used
before pass the DAD (Duplicate Address Detection), which is used to detect the
address conflicts. In the DAD process, the IPv6 address may in three different
status:
Normal: Indicates that the global address passes the DAD and can be normally
used.
Try: Indicates that the global address is in the progress of DAD and cannot be
used right now.
Repeat: Indicates that the global address is duplicated, this address is already
used by another node. This address cannot be used by the interface.
Speed Duplex FlowCtrl Jumbo
----- ------ --------
N/A
N/A
1000M Full
- T1500-28PCT
Active-Medium
--------- -------------
N/A Disable Copper
N/A Disable Copper
Disable Disable Copper
System Info Configurations
Configuration Guide 33