Configuring Mvr For The Ports - TP-Link Jetstream T1500G-8T User Manual

Configuring Layer 2 Multicast
Switch(config)#show mvr members
MVR Group IP
----------------
239.1.2.3
239.1.2.4
239.1.2.5
Switch(config)#end
Switch#copy running-config startup-config

4.2.3 Configuring MVR for the Ports

Follow these steps to configure MVR for the ports:
Step 1
Step 2
Step 3
Step 4
Step 5
Downloaded from ManualsNet.com
status
--------- ----------------
active
active
active
configure
Enter global configuration mode.
interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter interface configuration mode.
mvr
Enable MVR for the port.
mvr type { source | receiver }
Configure the MVR port type as receiver or source. By default, the port is a non-MVR port. If
you attempt to configure a non-MVR port with MVR characteristics, the operation fails.
source: Configure the uplink ports that receive and send multicast data on the multicast VLAN
as source ports. Source ports should belong to the multicast VLAN.
receiver: Configure the ports that are connecting to the hosts as receiver ports. A receiver
port can only belong to one VLAN, and cannot belong to the multicast VLAN.
mvr immediate
(Optional) Enable the Fast Leave feature of MVR for the port. Only receiver ports support Fast
Leave. Before enabling Fast Leave for a port, make sure there is only a single receiver device
connecting to the port.
search engine
Members
MVR Configuration
User Guide 252