Configuring LLDP
2.1.2 Configuring LLDP For the Port
Choose th menu L2 FEATURES > LLDP > LLDP Config > Port Config to load the following
page.
Figure 2-2 Port Config
Follow these steps to configure the LLDP feature for the interface.
1) Select one or more ports to configure.
2) Configure the Admin Status and Notification Mode for the port.
3) Select the TLVs (Type/Length/Value) included in the LLDP packets according to your
needs.
Downloaded from
ManualsNet.com
Admin Status
Set Admin Status for the port to deal with LLDP packets.
Tx&Rx: The port transmits LLDP packets and receives LLDP packets.
Rx_Only: The port only receives LLDP packets.
Tx_Only: The port only transmits LLDP packets.
Disable: The port will not transmit LLDP packets or drop the received LLDP
packets.
Notification
(Optional) Enable the switch to send trap messages to the NMS when the
Mode
information of the neighbor device connected to this port changes.
Management
Specify the Management IP address of the port to be notified to the neighbor.
Address
Value 0.0.0.0 means the port will notify its default management address to the
neighbor.
search engine
LLDP Configurations
User Guide
363