TP-Link Jetstream T1500G-8T User Manual page 616

Configuring ACL
Figure 2-10 Configuring the IP ACL Rule
Follow these steps to configure the IP ACL rule:
1) In the IP ACL Rule section, configure the following parameters:
Downloaded from ManualsNet.com
Rule ID Enter an ID number to identify the rule.
It should not be the same as any current rule ID in the same ACL. If you
select Auto Assign, the rule ID will be assigned automatically and the interval
between rule IDs is 5.
Operation Select an action to be taken when a packet matches the rule.
Permit: To forward the matched packets.
Deny: To discard the matched packets.
S-IP/Mask Enter the source IP address with a mask. A value of 1 in the mask indicates
that the corresponding bit in the address will be matched.
search engine
ACL Configuration
User Guide 593