Using The Cli; Adding Ipv6-Mac Binding Entries; Configuring Ipv6 Source Guard - TP-Link Jetstream T1500G-8T User Manual

Configuring IPv6 IMPB
2) Click Apply.
4.2

Using the CLI

4.2.1 Adding IPv6-MAC Binding Entries

The ND Detection feature allows the switch to detect the ND packets based on the
binding entries in the IPv6-MAC Binding Table and filter out the illegal ND packets. Before
configuring ND Detection, complete IPv6-MAC Binding configuration. For details, refer to
IPv6-MAC Binding

4.2.2 Configuring IPv6 Source Guard

Before configuring IPv6 Source Guard, you need to configure the SDM template as
EnterpriseV6.
Follow these steps to configure IPv6 Source Guard:
Step 1
Step 2
Step 3
Downloaded from ManualsNet.com
Port Displays the port number.
Security Type Select Security Type on the port for IPv6 packets. The following options are
provided:
Disable: The IP Source Guard feature is disabled on the port.
SIPv6+MAC: Only the packet with its source IPv6 address, source MAC address
and port number matching the IPv6-MAC binding rules can be processed,
otherwise the packet will be discarded.
SIPv6: Only the packet with its source IPv6 address and port number matching
the IPv6-MAC binding rules can be processed, otherwise the packet will be
discarded.
LAG Displays the LAG that the port is in.
Configuration.
configure
Enter global configuration mode.
interface { fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter interface configuration mode.
ipv6 verify source { sipv6+mac | sipv6 }
Enable IPv6 Source Guard for IPv6 packets.
sipv6+mac :
Only the packet with its source IP address, source MAC address and port
number matching the IPv6-MAC binding rules can be processed, otherwise the packet will
be discarded.
search engine
IPv6 Source Guard Configuration
User Guide 682