Configuring Mvr For The Ports - TP-Link T1600G-52TS User Manual

Configuring Layer 2 Multicast
MVR Group IP
----------------
239.1.2.3
239.1.2.4
239.1.2.5
Switch(config)#end
Switch#copy running-config startup-config

4.2.3 Configuring MVR for the Ports

Follow these steps to configure MVR for the ports:
Step 1 configure
Enter global configuration mode.
Step 2 interface {fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range
gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list }
Enter interface configuration mode.
Step 3 mvr
Enable MVR for the port.
Step 4 mvr type { source | receiver }
Configure the MVR port type as receiver or source. By default, the port is a non-MVR port. If
you attempt to configure a non-MVR port with MVR characteristics, the operation fails.
source:
as source ports. Source ports should belong to the multicast VLAN.
receiver:
port can only belong to one VLAN, and cannot belong to the multicast VLAN.
Step 5 mvr immediate
(Optional) Enable the Fast Leave feature of MVR for the port. Only receiver ports support Fast
Leave. Before enabling Fast Leave for a port, make sure there is only a single receiver device
connecting to the port.
Step 6 mvr vlan vlan-id group ip-addr
(Optional) Statically add the port to an MVR group. Then the port can receive multicast traffic
sent to the IP multicast address via the multicast VLAN.
This command applies to only receiver ports. The switch adds or removes the receiver ports
to the corresponding multicast groups by snooping the report and leave messages from the
hosts. You can also statically add a receiver port to an MVR group.
vlan-id
ip-addr
status Members
--------- ----------------
active
active
active
Configure the uplink ports that receive and send multicast data on the multicast VLAN
Configure the ports that are connecting to the hosts as receiver ports. A receiver
: Enter the multicast VLAN ID.
: Specify the IP address of the multicast group.
MVR Configuration
User Guide 249