Skoda FABIA II 2007 Workshop Manual page 1113

– Measure all the adjusting washers and prepare the corre‐
sponding adjusting washer for installation.
Caution
Risk of damage to gearbox!
♦ Mark adjusting washer SK2 and prepare it as follows for
installation.
♦ Only this adjusting washer SK2 may be used for adjust‐
ment.
The adjusting washer for K2 is then also determined. Please in‐
stall this adjusting washer when installing the clutch at a later
stage. This washer belongs under the small engaging bearing.
The clutch can be installed
⇒ "2.3 Install double clutch", page 69
1.3.2 Adjusting the clutch release mecha‐
nism, gearbox as of 06.2011
Special tools and workshop equipment required
♦ Gauge block - T10466-
♦ Straightedge - T40100-
♦ Digital depth gauge
Caution
When replacing the double clutch, the following parts must al‐
ways be replaced too:
♦ the two engaging levers with engaging bearings
♦ Ball pin of the engaging lever for clutch K2
♦ Shims for engaging bearing
After replacing the double clutch and the corresponding parts,
the position of the engaging bearings for clutches K1 and K2
will always require re-adjusting.
Note
If all the mentioned parts are only removed and reinstalled,
♦
there is nothing to adjust.
The circlip must be replaced under all circumstances.
♦
Short description
The position of the engaging bearing is comparable with the
clutch play of a mechanical manual gearbox. In the automatic
gearbox DSG - 0AM, there are tolerances in the engaging system
of the gearbox and in the gearbox itself. Tolerances also exist
inside the double clutch. These tolerances must be considered
separately when adjusting.
In the following procedure, you will first see how to determine all
the necessary dimensions on the gearbox side in order to identify
the suitable adjusting washer. The tolerances on the gearbox side
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
.
Gearbox 0AM-DSG - Edition 01.2015
51
1. Clutch operation