Skoda FABIA II 2007 Workshop Manual page 1053

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 09G - Edition 07.2014
– Remove gearshift lever -1-.
– Loosen both screws -B-.
Note
Do not release the screws.
– Fit the setting gauge - T10173- onto the gearshift shaft.
– Turn the multi-function switch -A- until the peg of the plug
-arrow 1- engages in the groove of the setting gauge -
T10173- .
If the peg of the plug cannot engage into the groove of the setting
gauge, then the gearbox is no longer in the position "N". In this
case, the gearbox must be shifted again with the setting gauge
into the position "N":
To do so turn the setting gauge to the front or to the rear, until the
peg of the plug -arrow 1- can engage into the groove of the setting
gauge - T10173- (if necessary slightly turn the multi-function
switch -A-).
– Fix the setting gauge - T10173 - to the gearshift shaft using a
knurled screw -C-
– Tighten both screws -B- to tightening torque 6 Nm.
– Remove setting gauge from gearshift shaft.
Further installation occurs in reverse order.
– Inspect setting of selector lever control cable
⇒ "2.3 Inspecting and adjusting the selector lever control ca‐
ble", page 55 .
188
Rep. gr.38 - Gears, control