Bleeding The Clutch Control (Octavia Ii) - Skoda Octavia II 2004 Workshop Manual

Install
The installation is performed in the reverse order, pay attention
to the following points:
– Connect the tube-hose line -1- with connectors at the master
cylinder and at the slave cylinder.
– For checking, pull on the line.
• After removing the hose clamp - MP7-602 (3094)- , it may be
necessary to bring the return hose -2- back into its initial po‐
sition.
Right-hand drive
– If present, coil the heat-protection matting in the sequence
-1, 2 and 3- around the cable.
– Secure the heat-protection matting with the circlip -4-.
Continued for all versions
– Bleed the clutch control
– Install the battery tray and battery ⇒ Electrical System; Rep.
gr. 27 .
1.24

Bleeding the clutch control (Octavia II)

Special tools and workshop equipment required
♦ Brake filling and bleeding device , e.g. -VAS 5234- or -ROM‐
ESS-
Note
When performing the following work, make sure that no brake
♦
fluid comes into contact with the frame side rail or the gearbox.
A pre-filling of the system is not necessary!
♦
Brake fluid specification ⇒ Chassis; Rep. gr. 00 .
– Remove air filter ⇒ Engine; Rep. gr. 24 .
– Connect the brake filling and bleeding device.
To bleed use the bleeder hose.
– Then connect ventilation hose with the drip bottle of the brake
bleeding device.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Octavia III 2013 ➤ , Octavia III ...
⇒ page 50 .
Gearbox 0AF - Edition 09.2013
1. Repairing clutch control
49