Adjust Clutch Release Mechanism - Skoda FABIA II 2007 Workshop Manual

1.3

Adjust clutch release mechanism

⇒ "1.3.1 Adjust clutch release mechanism, gearbox up to
05.2011", page 41
⇒ "1.3.2 Adjusting the clutch release mechanism, gearbox as of
06.2011", page 51
1.3.1 Adjust clutch release mechanism, gear‐
box up to 05.2011
Special tools and workshop equipment required
♦ Gauge block - T10374-
♦ Straightedge - T40100-
♦ Adhesive - AMV 195 KD1 01-
♦ Digital depth gauge
Caution
When replacing the double clutch, the following parts must al‐
ways be replaced too:
♦ the two engaging levers with engaging bearings
♦ Bearing of the engaging lever
♦ Shims for engaging bearing
After replacing the double clutch and the corresponding parts,
the position of the engaging bearings for clutches K1 and K2
will always require re-adjusting.
Note
If all the mentioned parts are only removed and reinstalled,
♦
there is nothing to adjust.
The circlip must be replaced under all circumstances.
♦
Conditions
• The mechatronics is installed.
• Double clutch gearbox removed
⇒ "2.2 Remove double clutch", page 66
• Only use proper tools.
• The flange of the clutch housing must be free of irregularities,
as the only way to ensure good contact with the straightedge.
Short description
The position of the engaging bearing is comparable with the
clutch play of a mechanical manual gearbox. In the automatic
gearbox DSG - 0AM, there are tolerances in the engaging system
of the gearbox and in the gearbox itself. Tolerances also exist
inside the double clutch. These tolerances must be considered
separately when adjusting.
In the following procedure, you will first see how to determine all
the necessary dimensions on the gearbox side in order to identify
the suitable adjusting washer. This has an impact on the clutch
tolerances determined earlier by the manufacturer. The toleran‐
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
41
1. Clutch operation