Install the Controller Hard Drive
Figure 4. Installing the Controller Hard Drive
1. Remove the Controller from its packaging.
2. Remove the Hard Drive from its packaging.
3. Locate the Hard Drive ribbon cable and power cable
in the Controller hard drive enclosure (see Figure 4
above).
4. Connect the cables in step 3 to the corresponding
connectors on the Hard Drive.
5. Insert the Hard Drive as shown in Figure 4 above.
6. Secure the Hard Drive plate to the Controller using
the screws provided with the Hard Drive.
Next: Go to "Install the System ID Module" below.
Power Cable
Ribbon Cable
Installation
17