Table of Contents
Advertisement
Autotest Settings
Chapter 4
The WireScope 350 Autotest is designed to be very flexible to support the wide
range of cabling certification requirements that you may encounter in the field.
Before you start testing, it is important to verify that Autotest settings match
your certification requirements.
Editing Autotest Settings
To edit autotest settings, start at the main menu screen. Press Autotest. This
brings up the Autotest Setup screen. The Autotest Setup screen summarizes a
few key settings. You can either start an autotest from this screen or edit
settings.
To view and edit any autotest settings, from the Autotest Setup screen, press
Edit Settings. The Autotest Settings screen will open up.
The Autotest Settings screen lists all of the current autotest setting categories
and summary status for each. To view or edit any setting, first select it either by
touching it or by moving the dark blue highlighting using the
indicated by a darker blue color highlight.
The currently selected
setting is show n in dark
blue.
List of autotest setting
categories. Summary
status for each setting
is show n in-line on this
screen.
Preparing to Run an Autotest 26
key. Selection is
Advertisement
Table of Contents
