Table of Contents
Advertisement
CAUTION:
Chapter 5
Voltage Warning
The voltage warning LED indicates that the DualRemote 350 is plugged into a
line, which has a potentially damaging high voltage present. Usually, this
condition occurs when attempting to test a line plugged in to a telephone switch.
IMMEDIATELY DISCONNECT THE DUALREMOTE350 FROM THE LINE
WHEN THIS WARNING APPEARS.
Failure to do so may cause permanent damage to the DualRemote 350 hardware.
Calibration Required
The Calibration Required LED indicates that the DualRemote 350 needs to be
recalibrated with the WireScope 350.
You will not be able to proceed with the autotest until the calibration process is
complete.
Battery
The battery LED indicates the current state of the DualRemote 350 battery.
When the DualRemote 350 is plugged into the AC charger:
·
A solid green color means the battery is charging.
·
A flashing green color means that the battery is fully charged.
Use only the 12V charger/adapter supplied with your WireScope and
DualRemote. Using an incompatible charger/adapter can damage your
WireScope equipment and void your warranty.
When the DualRemote 350 is not plugged into the AC charger:
When the battery LED is off, the battery operating normally.
·
A solid red color means that the battery charge is low.
·
Progress indicator
The progress LEDs indicates approximately how much of the current test is
complete.
Test One Third
Complete
Pass / Fail
The Pass / Fail LED indicates the pass / fail status of the last completed test.
Green indicates pass
·
Red indicates fail
·
Test Half
Complete
Running an Autotest 57
Test
Complete
Advertisement
Table of Contents
