Table of Contents
Advertisement
The WireScope 350 then copies the profile from the card and asks you if you
want to load the profile. To do so, press Yes; to abort, press No. Once the upload
is completed, the display tells you that you can remove the CFlash card.
The autotest profile is now ready for your selection and use. For our example,
the profile is named "test." To view and select the profile from the Autotest
Setup screen, press Edit Settings. On the next screen, with the Profile
parameter selected, press Edit. The Profile Setup screen is displayed with all
available profiles listed. The downloaded profile "test" is added to the list. To
use this profile, press to select that profile, then press OK. The sequence of
screens is shown below.
Chapter 15
WireScope 350 System Settings 116
Advertisement
Table of Contents
