Table of Contents
Advertisement
The first Connector Setup configuration screen prompts you to specify the
manufacturer of the connecting hardware that you will be testing. If you do not
know the manufacturer, select "unspecified". Use the
key if you need to scroll
the list of manufacturers. In the example below, "Lucent" is selected. Then,
press
or Next.
The Connector Setup configuration screen prompts you to either enter/edit a
connector description or select one from the list already stored on the WireScope
350. If you see the part number of the connecting hardware you are using, select
it and press
or OK to complete connector selection and return to the
Autotest Settings screen.
If you do not see the connecting hardware you are using already listed in the
WireScope 350, select Add New Description and follow the instructions to add
the specification data for the new connector.
Chapter 4
Preparing to Run an Autotest 33
Advertisement
Table of Contents
