Table of Contents
Advertisement
Test Probes
SmartProbe
Interface
CAUTION:
Chapter 4
SmartProbe Port Interface
The WireScope 350 uses test probes to connect to the cabling runs that it
certifies. All WireScope 350 test probes attach though the SmartProbe port at
the top of the WireScope and DualRemote enclosures. The SmartProbe port
provides high performance for test signal transmission, power to support active
probes, and a two-way control interface between the tester and the test probe. A
variety of test probes are available, including SmartProbes that track usage and
configuration data.
WireScope probe configuration warnings
Because it is important to use the correct test probes in order to achieve optimal
measurement results, particularly for category 6 installations, the WireScope
350 warns you whenever it detects a potential conflict between the detected
probe and any of the test settings. This you to avoid wasting time testing with
the wrong probes or with the wrong tester settings.
If the WireScope detects an over-voltage condition at the SmartProbe port, it
displays an error message An example of this warning is provided below:
An example of the over-voltage warning given on the DualRemote 350 is shown
on page 57.
Do not connect WireScope test probes or test cables to a voltage source,
such a telephone jack. Excessive voltages can damage WireScope probes
and/or the WireScope 350 analyzer and void your warranty.
Preparing to Run an Autotest 24
Advertisement
Table of Contents
