Table of Contents
Advertisement
NOTE:
Chapter 4
If you uncheck any of the required measurements, these tests will still be
performed during the autotest, but will not be used for determining pass/fail
status.
You can specify optional measurements and analyses to be included in the
autotest by checking the applicable boxes.
You can also set the frequency step size and the format used to store pair to pair
ELFEXT data.
If you set the WireScope 350 to Fast Check Mode, you will not collect enough
data to certify the tested cabling runs.
Either ELFEXT mode captures all of the worst case ELFEXT data points.
Preparing to Run an Autotest 35
Advertisement
Table of Contents
