Table of Contents
Advertisement
Attach FiberProbes
Chapter 10
Preparing to Run a Fiber Autotest
The Fiber Autotest is a comprehensive test that reports PASS/FAIL results
based on user configurable limits. The Fiber Autotest will optionally generate
PASS/FAIL results for the fiber optic network specifications stored in the
Network Database.
Before you run the Autotest, however, it is important to verify that you have
properly prepared the WireScope 350 for your certification project.
The WireScope 350 has the ability to detect the characteristics of the attached
Fiber SmartProbes. Based on this information this interface automatically brings
up the Fiber Main Menu screen once the Fiber SmartProbe is attached. You are
now ready to configure the Fiber Autotest settings.
The key to providing this capability is that the SmartProbe interface port warns
the operator if there is a potential invalid configuration before testing starts.
Viewing probe information
To access probe information, from the Fiber Autotest Settings screen, select the
probe icon and press
SmartProbe
Interface
or View.
Preparing to Run a Fiber Autotest 75
Chapter 10
WireScope and
DualRemote tabs
summarize
information about
attached probes.
Advertisement
Table of Contents
