Table of Contents
Advertisement
Chapter 10
The next Connector Setup configuration screen prompts you to either select a
connector from the list stored on the WireScope 350 or add a new description.
If you see the part number of the connecting hardware you are using, select it
and press
or OK to complete connector selection and return to the
Autotest Settings screen.
If you do not see the connecting hardware you are using already listed in the
WireScope 350, select Add New Description and follow the instructions to add
the specification data for the new connector.
Save to: Storage Location setting
This setting allows you to choose where to save test results.
If a CompactFlash™ memory card is inserted, the default choice is to
save test results to the CompactFlash™ card.
Otherwise, the default choice is to save results to the internal flash
memory.
Select the test results storage icon and press
the test result storage setting.
or the Edit button to change
Preparing to Run a Fiber Autotest 89
Advertisement
Table of Contents
