Table of Contents
Advertisement
Calibration Information
Selecting Calibration Information, then View in the System Settings screen
tells you the date when the base line or factory calibration was performed on the
WireScope 350 and DualRemote 350. It lists the serial numbers for both units
followed by the date they were calibrated. The region at the bottom lists the
software revision of the two units, followed by the date the last calibration
(copper or fiber) was performed in the field.
Autoprint
The Autoprint feature, when enabled, permits on-site automatic label printing on
a Brady TLS2200 printer after each test record is saved. (See
http://www.bradydatacomm.com/ for information on the TLS2200 printer.)
Press Autoprint to enable this feature (enabled when check mark is present).
Connect the serial printer to the RS-232 serial port (see page 140).
Chapter 15
WireScope 350 System Settings 134
Advertisement
Table of Contents
