Table of Contents
Advertisement
Chapter 8
When the Coax probe is inserted a default Coax cable is automatically selected.
You can change to a different Coax cable in the Autotest Settings screen.
The WireScope 350 is capable of certifying 10Base-2 and 10Base-5 network
operation over Coax. By selecting Other in the Network Limits of the Autotest
Settings screen, or in the Summary screen of the Certify Networks screen, you
can enable the certification of these networks.
Press the Start Test button from the Autotest Setup screen to perform the Coax
Autotest (or Certify Network test).
Results
After the test has completed, the Autotest result screen below on the left will
appear.
The Coax Autotest evaluates length and cable integrity. These results are shown
in both the diagram at the top of the screen and the table at the bottom. Delay
and NVP information are also shown. The results of coax network certification
are also shown in the bottom section of the result screen. Press the Details
button to display the Wiremap Data screen containing additional information
about the test.
Running COAX and TWINAX Autotests 70
Details
screen
Advertisement
Table of Contents
