Table of Contents
Advertisement
NOTE:
Chapter 4
Press
or the Edit button to open the configuration screen(s) for the selected
setting. Once you have opened the configuration screen(s) for any setting, there
will be instructions to guide you through any changes to that setting. When you
exit the configuration screen(s) for any setting, you will return to the Autotest
Settings screen.
Select (or create new) an autotest profile as directed on page 40. Standard
profiles for Cat 5, Cat 5e, and Cat 6 are pre-defined in WireScope software.
Setting cabling limits
Perhaps the most important setting is the cabling performance limit to apply
during pass/fail certification of autotest results. To edit the cabling limit setting,
select it from the list of autotest settings and press
open the cabling limit configuration screens.
The Limit Setup configuration screens step you through the process. The first
step is selecting the category, class or custom limit. Press
continue.
or the Edit button to
or Next to
Preparing to Run an Autotest 27
Advertisement
Table of Contents
