Table of Contents
Advertisement
Saving test results
Using auto-increment
Starting the next Autotest
Chapter 11
When you press the Save button, the Save Results screen appears. Each saved
test result record must have a unique cable label. There are several options for
entering the cable label for the saved test result:
·
You can use a typewriter-style keyboard
·
You can use a telephone-style keypad
·
You can pick an already-saved label from a list
Or, if a label list has been loaded, you can select a label from the list of
·
cable IDs.
Details for entering data using the keyboard, keypad, or using a list are given on
page 21.
Often, if you are testing cabling runs in a predictable sequence, it can save time
to configure the WireScope 350 to auto-increment cable labels. With auto-
increment, you dramatically reduce the amount of data entry that you must do.
To setup cable label auto-increment, please see Site Settings in Chapter 4. In the
example sequence below, auto-increment is set for the panel and position fields
of a hierarchical cable label format.
First test is
labeled Panel 1,
Position A
From the Fiber Autotest Result screen, you can start another Autotest by
pressing the Start button. If you have already saved the previous test, the
Autotest will start without any further delay. If you have not yet saved the
previous test, a dialog box will pop up to confirm that you wish to start another
test without saving the previous result.
.
Press Start to start the next test.
Second test is
labeled Panel 1,
Position B
Running Fiber Autotest 96
Advertisement
Table of Contents
