To Perform Internal Storage And Recall - Rigol DS4024E User Manual

RIGOL

To Perform Internal Storage and Recall

The internal memory supports the storage and recall of setup files, reference
waveform files and pass/fail test mask files. In the following section, the internal
storage and recall method and procedures are introduced by taking the setup file as
an example.
1. Save the specified oscilloscope setting in internal memory
1) Connect the signal to the oscilloscope and set the oscilloscope parameters to
obtain stable display.
2) Press Storage  Storage; turn the multi-function knob
"Setups" and press the knob. You can also press Storage continuously to
switch to "Setups".
3) Press Save to turn on the disk management interface. Turn the
multi-function knob
and press down the knob to open the local disk storage interface.
4) The local disk can store at most 10 setup files. Turn the multi-function knob
to select the desired storage location and Save becomes available; then
press the softkey to execute the saving operation. If the current location
contains a file, you can press Save  OK to directly overwrite the original
file or press Delete to delete the file.
Note:
Turn the multi-function knob

the knob to return to the previous directory.
In internal storage, New File and New Folder are not available.

Tip
Pressing REF  Export can enter the disk management interface of
1.
reference waveform file storage.
Pressing Utility  Pass/Fail  Save can enter the disk management
2.
interface of pass/fail test mask file storage.
2. Recall the setup file stored in internal memory
1) Press Storage  Storage; turn the multi-function knob
"Setups" and press the knob. You can also press Storage continuously to
switch to "Setups".
2) Press Load to open the disk management interface. Turn the multi-function
12-6
to select "Local Disk" (the characters turn green)
to select
Chapter 12 Store and Recall
to select
and then press down
to select
DS4000E User's Guide