Removing A Bri Digital Line Card; Configuring And Managing E1 Digital Line Cards - 3Com NBX 100 Administrator's Manual

182 C 3: D
HAPTER EVICE
Removing a BRI
Digital Line Card
Configuring and
Managing E1
Digital Line Cards
C
ONFIGURATION
You can remove a Digital Line Card at any time.
CAUTION: Removing a Digital Line Card may affect your Dial Plan.
To remove a Digital Line Card:
1 On the Digital Line Cards tab, from the Select Device Type drop-down list,
select T1/ISDN Board List and click Apply. A list of installed T1, ISDN PRI,
or ISDN BRI boards appears in the T1/ISDN Board List.
2 Select the board (Digital Line Card) you want to remove from the list.
3 Click Remove. A dialog box prompts you to confirm the removal.
4 Click Yes.
This section describes how to add and configure an E1 Digital Line Card
to connect to an E1 service provided by the local telephone company. You
can configure an E1 Digital Line Card for ISDN PRI signaling only. In the
NBX NetSet utility, Digital Line Cards are referred to as either cards or
boards.
These topics explain NBX E1 card configuration:
Adding an E1 Digital Line Card
Configuring an E1 Digital Line Card
E1 Card Status Lights
Modifying an E1 Card
Adding or Modifying an E1 Group
Modifying E1 Card Channels
Modifying IP Settings for an E1 Card
Removing an E1 Digital Line Card
3C10165D E1 Digital Line Cards have expanded capabilities that are
described in these topics:
Setting Up a Digital Line Card at a Remote Location
Setting Up T1/E1 Logging
Viewing CSU State Information and Statistics
Using Loopback Tests