Alarms On Nbx Digital Line Cards - 3Com NBX 100 Administrator's Manual

378 C 11: T
HAPTER ROUBLESHOOTING
Alarms on NBX
Digital Line Cards
when the far end equipment enters a Red CFA state. See Red Alarm,
earlier in this section.
NBX T1 and E1 Digital Line Cards support all of the alarm states and
signals described in "Alarm Descriptions"
and Table 69 on page 379
conditions on digital line cards.
Table 68 3C10165, 3C10165B, 3C10165C, 3C10116, and 3C10116C Status
Lights and Error Conditions
Status Light Purpose
Nominal On: There are no error or alarm conditions.
Flashing: A call is active on at least one channel.
CF (Carrier Fail) On: A Red Alarm state or Blue Alarm state exists on the card.
To determine which alarm state exists:
1 Log on to the NBX NetSet utility using the administrator ID
2 Click Device Configuration > Digital Line Cards.
3 In the Select Device Type list, select T1 Span List or ISDN
4 Select the span you want and click Status. The words Red
RA (Remote Alarm) On: A Yellow Alarm state on the card. To confirm that the
Yellow Alarm state exists:
1 Log on to the NBX NetSet utility using the administrator ID
2 Click Device Configuration > Digital Line Cards.
3 In the Select Device Type list, select T1 Span List or ISDN
4 Select the span you want and click Status. The words
NOTE: This light is used only on the T1 Digital Line Card.
LB (Loop Back) On: The card is in loop-back testing mode.
NOTE: This light is not used to indicate any of the Red, Blue,
or Yellow alarms.
on
describe how the status lights indicate alarm
and password.
PRI Span List, and then click Apply.
Alarm or Blue Alarm appear in the Status field.
and password.
PRI Span List, and then click Apply.
Yellow Alarm appear in the Status field.
page 377. Table 68, next,