System-Wide Settings - 3Com NBX 100 Administrator's Manual

System-wide Settings

Table 31 System Settings (continued)
Field
System Start Time
You use the System-wide dialog box to make changes to System-wide
settings. Table 32
To configure system-wide settings:
1 Log on to the NBX NetSet utility using the administrator login ID and
password.
2 Click System Configuration > System Settings > System-wide. See the
Help for procedures on modifying system-wide settings.
Table 32 System Settings System-wide Dialog Box Fields
Field
Host Name
SMTP Domain
Name
IP Address
Default Gateway
Subnet Mask
Primary DNS
Secondary DNS
Tertiary DNS
Purpose
The last time the system was initialized (boot time).
describes each setting.
Purpose
An IP setting for the NBX system.
A Host name functions only if you add the name to the name
resolution system. If you do not do this, then you must enter
the IP address in the browser when you want to access NBX
NetSet.
The name of your SMTP domain.
Required for Off-Site Notification by e-mail.
The IP address of the NBX system.
The IP address of the destination host for any IP packet not
addressed to a host on the local subnetwork.
An IP setting that identifies the network and host portions of
an IP address on the network.
The IP address of the primary DNS server. You must specify at
least a primary address to use e-mail Off-Site Notification.
The IP address of the secondary DNS server. If you specify two
DNS IP addresses, they must be the primary and secondary
addresses.
The IP address of the tertiary DNS server.
System Settings 251