Configuring An E1 Digital Line Card - 3Com NBX 100 Administrator's Manual

Configuring an
E1 Digital Line Card
E1 card and begins to update its database. Allow 3 minutes for both of
these processes to be completed.
You are now ready to configure the E1 Digital Line Card.
These sections tell you how to use the NBX NetSet utility to set up your
E1 Digital Line Card parameters.
Configuring for ISDN PRI Signaling
Configuring E1 Groups
Verifying E1 Group Membership
Completing the E1 Configuration
Verifying E1 Span Status
Before you configure an E1 card, you must configure the Dial Plan as
described in Chapter
Configuring for ISDN PRI Signaling
Before you configure the E1 card, read the cautionary note. This section
describes how to configure an E1 Digital Line Card for ISDN PRI (Primary
Rate Interface) signaling.
CAUTION: Before you configure the E1 card, you must wait 3 minutes
after you insert the E1 card into the chassis.
1 Select NBX NetSet > Device Configuration > Digital Line Cards.
2 Use the MAC address of the E1 card to identify the board in the T1/ISDN
Board List. You recorded this address before inserting the board into the
chassis.
3 Select the E1 board from the T1/ISDN Board List and click Modify.
4 Scroll through the Channel List to verify that the system lists all
30 channels. The channel numbers appear after the MAC address,
separated by a hyphen.
Example:
1...00:e0:bb:04:4e:a5-4 Trunk
The 4 after the hyphen indicates channel number 4.
5 To change the name of the E1 board, edit the contents of the Board
Name field. This name helps you identify the E1 board in a list.
Configuring and Managing E1 Digital Line Cards
2.
185