3Com NBX 100 Administrator's Manual page 272

272 C 5: S
HAPTER YSTEM
C
ONFIGURATION
4 Install the second disk drive.
a Unlock the disk tray.
b Unscrew the two retaining screws.
c Remove the disk tray.
d Connect the IDE disk cable to the disk drive.
e Connect the power harness to the disk drive.
f Fasten the new disk to the disk tray using your Phillips screwdriver and
the screws provided with the disk.
g Reinsert the disk tray.
h Screw in the two retaining screws and lock the disk tray in place.
5 Restart the system.
6 Verify that the disks begin the mirroring process.
On the Call Processor front panel, check the four LEDs under the PWR
and S1 labels. The LEDs labeled 1, 2, and 3
status.
Figure 21 Disk and Power LEDs
P
S
W
1 R
1
2
3
Table 39 describes the possible states of the LEDs.
Table 39 Disk LED States
Explanation
Attempting to boot from disk 0 (zero)
Attempting to boot from disk 1
Boot process completed, system initializing
System is running
(Figure 21) indicate disk
LED 1 LED 2 LED 3
Off On Off
Off Off On
Flashing N/A N/A
On N/A N/A
PWR
On
On
On
On