3Com NBX 100 Administrator's Manual page 250

250 C 5: S
HAPTER YSTEM
C
ONFIGURATION
To view system settings:
1 Log on to the NBX NetSet utility using the administrator login ID and
password.
2 Click System Configuration > System Settings.
System Settings fields.
Table 31 System Settings
Field
Software Version
System Serial #
Host Name
IP Address
Default Gateway
Subnet Mask
Network Protocol
MOH MAC Address
Free Memory
Memory Upgrade
Installed
Date and Time
Purpose
The call control software for the NBX system.
The serial number on the Call Processor circuit board.
This is an IP setting. It is a name you can give to the NBX
system so you do not have to specify the IP address when
accessing NBX NetSet through a browser.
The IP address of the NBX system.
The IP address of the destination host for any IP packet not
addressed to a host on the local subnetwork.
An IP setting that identifies the network and host portions
of an IP address on the network.
The transport mechanism for voice packets.
Ethernet only: All communications are at the Ethernet
frame layer.
Standard IP: IP communications are used for traffic
between NBX system addresses. Every device needs an
IP address.
IP On-the-Fly: An implementation of IP communications in
which Layer 2 (Ethernet) devices are temporarily assigned a
Layer 3 (IP) address only when they need to communicate
with a Layer 3 device on a different subnetwork. The IP
address is assigned from an address pool defined by the
NBX system administrator. After the Layer 2 device returns
to the idle state the IP address is returned to the pool of
available addresses for future use.
The hardware address of the Music-on-Hold device.
Available memory on the NBX system.
Indicates whether this NBX system has had a memory
upgrade. Possible values are:
Yes (NBX V3000, SuperStack 3 NBX)
No (NBX V3000, SuperStack 3 NBX)
N/A (NBX 100)
The current system date and time. To modify, click the Date
and Time button.
Table 31 describes the