3Com NBX 100 Administrator's Manual page 396

396 A B: ISDN C
PPENDIX
Table 73 Completion Cause Codes (continued)
Hex
Class Grouping Code
0x52
0x53
0x54
0x55
0x58
0x5B
0x5F
Protocol error 0x60
0x61
0x62
0x63
C C
OMPLETION AUSE ODES
Decimal
Code Description
82 Chan does not
exist
83 Suspended call
exists, call
identity does
not
84 Call identity in
use
85 Incompatible
destination
88 Incompatible
destination
91 Transit network
does not exist.
95 Invalid message
(unspecified)
96 Mandatory IE
missing
97 Nonexistent
message
98 Wrong
message
99 Bad info
element
Details
The equipment sending this cause has received a request to
use a channel that is not activated on the interface for a
call.
A call resume has been attempted with a call identity that
differs from that in use for any currently suspended calls.
The network has received a call suspended request that
contained a call identity (including the null call identity) that
is already in use for a suspended call within the domain of
interfaces over which this call may be resumed.
The equipment sending this cause has received a request to
establish a call that has low layer compatibility, high layer
compatibility, or other compatibility attributes (for example,
data rate) that cannot be handled.
Reports an invalid message event only when no other cause
in the invalid message call applies.
The equipment sending this cause has received a message
that is missing an information element that must be present
in the message before that message can be processed.
The equipment sending this cause has received a message
with a message type that it does not recognize, either
because it is an undefined message, or it is defined but not
implemented by the equipment sending the cause.
The equipment sending this cause has received a message
that it considers as not permitted while in the call state; or a
STATUS message was received indicating an incompatible
call state.
The equipment sending this cause has received a message
that includes information elements not recognized because
the information element identifier is not defined, or it is
defined but not implemented by the equipment sending
the cause. However, the information element is not
required to be present in the message to enable the
equipment sending the cause to process the message.