Modifying Ip Settings For A Bri Card - 3Com NBX 100 Administrator's Manual

Modifying IP Settings
for a BRI Card
Viewing Digital Signal Processor Status
To view DSP (Digital Signal Processor) details:
1 Return to the Digital Line Cards tab.
2 From the Select Device Type list, select T1/ISDN Board List and click Apply.
3 Select the BRI card you want and click Status.
4 In the Board Status dialog box, select a DSP from the DSP List and click
Details. The DSP Status window appears.
5 Click Close to close the DSP Status window.
6 Click OK.
You can modify the IP settings for a Digital Line Card to meet changing
requirements.
The card must be on the same subnetwork as the Call Processor to
modify IP settings using the NBX NetSet utility.
To modify the IP settings of a BRI Digital Line Card:
1 On the Digital Line Cards tab, from the Select Device Type drop-down list,
select T1/ISDN Board List.
2 Click Apply.
3 Select the BRI card for which you want to change the IP settings.
4 Click IP Settings.
5 To assign IP addresses, enter the first address in the First IP Address field.
The system sequentially adds the remaining addresses.
To assign IP addresses one at a time per channel:
1 In the Digital Line Card IP Settings dialog box, click Assign Addresses
Individually.
2 Enter the desired IP addresses for the channels.
3 Enter the mask number appropriate for your site in the Common Subnet
Mask field.
4 Enter IP address for the Common Default Gateway.
5 Click Apply.
6 Click OK.
7 In the Digital Line Card IP Settings dialog box dialog box, click OK.
Configuring and Managing BRI-ST Digital Line Cards 181