Removing An E1 Digital Line Card - 3Com NBX 100 Administrator's Manual

196 C 3: D
HAPTER EVICE
Removing an E1
Digital Line Card
C
ONFIGURATION
system's NCP, you must first discover the card by connecting it to the
same subnet as the NCP. That procedure is described in
Digital Line Card at a Remote Location"
3C10165D E1 Digital Line Cards do not support DHCP lease times of
less than 20 minutes.
To modify the IP settings of a Digital Line Card:
1 Select NBX NetSet > Device Configuration > Digital Line Cards.
2 From the Select Device Type drop-down list, select T1/ISDN Board List.
3 Click Apply.
4 Select the board (ISDN PRI) for which you want to change the IP settings.
5 Click IP Settings.
6 To assign IP addresses automatically, enter the first address in the
First IP Address field. The system sequentially adds the remaining
addresses. 3C10165D E1 Digital Line Cards work need only one IP
address.
To assign IP addresses one at a time:
1 In the Digital Line Card IP Settings dialog box, click Assign Addresses
Individually.
3C10165D E1 Digital Line Cards work need only one IP address, so the
Assign Addresses Individually button is not present for these cards.
2 Enter the desired IP addresses for the channels.
3 Enter the mask number for your site in the Common Subnet Mask field.
4 Enter IP address for the Common Default Gateway.
5 Click Apply.
6 Click OK.
7 In the Digital Line Card IP Settings dialog box, click Apply.
8 Click OK.
You can remove a Digital Line Card at any time.
CAUTION: Removing a Digital Line Card may affect your Dial Plan.
"Setting Up a
on page 220.