Removing A Bri Digital Line Card; Configuring And Managing E1 Digital Line Cards - 3Com SuperStack 3 NBX Administrator's Manual

Removing a BRI
Digital Line Card
Configuring and
Managing E1
Digital Line Cards
You can remove a Digital Line Card at any time.
CAUTION: Removing a Digital Line Card may affect your Dial Plan.
To remove a Digital Line Card:
1 From the NBX NetSet - Main Menu window (Figure 97), click Device
Configuration.
2 Click the Digital Line Cards tab (Figure 98).
3 From the Select Device Type pull-down list, select T1/ISDN Board List and
click Apply. A list of installed T1, ISDN PRI, or ISDN BRI boards appears in
the T1/ISDN Board List.
4 Select the board (Digital Line Card) you want to remove from the list.
5 Click Remove. A dialog box prompts you to confirm the removal.
6 Click Yes.
This section describes how to add and configure an E1 Digital Line Card
( ) to connect to an E1 service provided by the local telephone
3C10165A
company. In the NBX NetSet utility, Digital Line Cards are referred to as
either cards or boards.
This chapter covers these topics:
Adding an E1 Digital Line Card
■
Configuring the E1 Digital Line Card
■
E1 Card Status Lights
■
Modifying an E1 Card
■
Adding or Modifying an E1 Group
■
Modifying E1 Card Channels
■
Modifying IP Settings for an E1 Card
■
Removing an E1 Digital Line Card
■
You can configure an E1 Digital Line Card for ISDN PRI signaling only.

Configuring and Managing E1 Digital Line Cards

259