Removing And Installing Cylinder Head Cover - Skoda Octavia 1996 Service Manual

15
------------ 15-6 ------------
Cylinder Head/Valve Gear
Installing
Note:
Replace gaskets if damaged.
- Fit top part of intake manifold onto the bottom
part.
- Press in retaining lugs on left and right until
they engage.
- Coat collar of bolts of rear intake manifold
suspension with commercially available
lubricant and tighten to 10 Nm.
- Adjust throttle cable ⇒ page 20-13.
- Pour in coolant, if necessary ⇒ page 19-2.
- Interrogate fault memory, carry out basic
setting:
⇒ 1.6-ltr./74 kW Engine, Simos 2 Fuel Injection
and Ignition System; Repair Group 01; Self-
Diagnosis; Interrogating and erasing fault
memory, basic setting of engine
Removing and installing cylinder
head cover
Special tools, testers and aids required
♦ Torque wrench 5...50 Nm
(e.g. V.A.G 1331)
Removing
- Remove top part of intake manifold
⇒ page 15-4.
- Remove top toothed belt guard.
- Unscrew nuts for cylinder head cover.
- Take off reinforcing strips, bracket, toothed
belt guard and cylinder head cover.
Installing
Note:
Replace gasket if damaged.
- Fit on cylinder head cover, reinforcing strips,
toothed belt guard and bracket.
- Tighten nuts diagonally across to 10 Nm.
OCTAVIA
Edition 05.97
S00.5105.51.20