Overview; Basic Setup Procedure; Inspection, Cleaning, And Packaging; Initial Inspection - Xantrex XDC 10-1200 Operating Manual

Installation

Overview

Chapter 2, "Installation" provides recommendations and procedures for
inspecting, installing, and testing the power supply. For more information about
controls and connectors, refer to the front panel diagrams (Figure 1-1 to Figure 1-
5) as well as the rear panel diagram (Figure 1-6) in Chapter 1.

Basic Setup Procedure

Table 2-1 provides a summary of the setup procedure and an overview of the
subsections in this chapter. Use this table as a quick reference if you are familiar
with the installation requirements for the power supply. If you require more
information, each step in the table refers to a subsequent section which contains
more details. Complete each step in the sequence given.

Table 2-1 Basic Setup Procedure

Step # Description
1 Inspection
2 Installation
3 Input Power
4 Test
5 Select Wires
6 Connect Load
7 Connect Remote
Sensing
(if required)

Inspection, Cleaning, and Packaging

Initial Inspection

When you receive your power supply, do a quick visual check.
1. Ensure that the box contains the power supply, the operating manual, the AC
2. Inspect the unit for scratches and cracks as well as broken switches,
2–2
Action
Visually inspect the power supply.
Install the power supply, ensuring adequate
ventilation.
Connect AC input power.
Perform functional tests for voltage mode
operation, current mode operation, and front
panel controls.
Select wires that can tolerate the DC current
output.
Connect the load wires to the DC output.
Connect remote sensing connectors on power
supply to load.
input cover and strain relief, and the output cover.
connectors, or displays.
Reference
"Inspection, Cleaning, and
Packaging" on page 2–2
"Location, Mounting, and
Ventilation" on page 2–4
"AC Input Power" on page 2–7
"Basic Checks or Self-Tests" on
page 2–13
"Load Wiring" on page 2–16
"Load Connections" on page 2–18
"Remote Sensing" on page 2–24
TM-XDOP-01XN