Control Knobs - Xantrex XDC 10-1200 Operating Manual

10. DISPLAY CFG: Sets up the display to show the desired combination of
11. KNOB LOCKOUT: Locks out either the Voltage or Current knob, or locks
12. SETPT LIMIT: Sets up minimum and maximum voltage, current, and power
13. SLEW RATE: Sets the programmable slew rate. (See page 3–49.)
14. CALIBRATION: Displays the Calibration menu. This menu item can be
15. MODEL INFO: Displays make, electrical ratings, ROM version, FPGA

Control Knobs

The Voltage and Current knobs are the simplest way to control the power supply.
The Voltage and Current knobs are digital encoders, and therefore, there are no
start or end points to their rotation, and their rotation positions are meaningless
when the power supply is powered OFF. The control knobs can be disabled
through a menu command. See "Lock Out Control Knobs" on page 3–44 for more
information.
TM-XDOP-01XN
voltage, current, and power. (See page 3–43.)
out both. (See page 3–44.)
setpoints. (See page 3–45.)
password protected. (See Chapter B, "Calibration (6000 Watt only)".)
version, and SCPI version. (See "View Model Information" on page 3–50.)
Front Panel Controls
3–7