Security Code - Xantrex XDC 10-1200 Operating Manual

Security code

To protect calibration data, a security code is required to enter calibration mode.
The security code set at the factory to "0000."
The password can be changed from the remote interface or the front panel.
Calibration state must be ON to change the password. From the front panel, select
"Change Code" from the calibration menu and enter the new code.
To change the Calibration security code:
If you have entered a valid code, the prompt displays Output V Cal. You can
either continue working with the calibration options or press EXIT to leave
calibration mode.
The SCPI command to change the security code is:
CAL:CODE <security_code>
The security code is any 4-digit number enclosed by quotation marks. Trying to
change the password to an invalid one causes an error.
TM-XDOP-01XN
Step # Do This
1
2
or
Scroll to select Change Code.
3 Enter a new 4-digit code.
4 You are back in the Calibration menu.
You Will See
Output V Cal
Change Code
Code ####
ENTER
Output V Cal
Entering Calibration Mode
B–5