Store User Settings - Xantrex XDC 10-1200 Operating Manual

Table 4-8 Features Affected by Reset (*RST) Command

Store User Settings

If you have a frequent or constant need for a specific voltage and current output,
you can save these setpoints in the power supply's memory as a user setting. Once
a setting is stored, it remains in the power supply's memory after the unit is
powered off.
See "Store User Settings" on page 3–21 for a list of parameters that are saved.
To store (save) settings:
*SAV <user-setting>
Example:
*SAV 1 will save all the present settings to user setting location 1.
To recall settings:
*RCL <user-setting>
To save default settings:
*SDS <user-setting>
This will save factory default settings to a user setting location, replacing any
setting that was previously saved there.
Example:
To save settings, set up the power supply with all required settings (we
recommend that you do this right after recalling the factory default settings).
For example, you can set voltage, current, and all protection levels.
Then to save the settings to Location 1: issue the command *SAV 1
When you want to recall the settings, issue the command *RCL 1. If you want to
recall them at the next power on, issue the command:
OUTP:PON:REC USER1
TM-XDOP-01XN
Feature
Triggered power setpoint
Autosequence mode
Front panel display config
Knob lockout
Calibration mode
Output
SCPI Commands for Digital Interfaces
Reset State (*RST)
Disabled (Default)
Exit
Show V & I
None
False
Disabled
4–25