Change Remote/Local Control Of Power Supply; Enable Output - Xantrex XDC 10-1200 Operating Manual

Remote Operation
To recall last settings:
If you wish to recall the settings present when the supply was last powered off,
send the command:
SYST:REC:LAST

Change Remote/Local Control of Power Supply

A SCPI command is provided for use with the RS-232 and multichannel
interfaces to change the remote/local mode. (GPIB will use IEEE 4888-1
functions to change modes.)
SYST:REM:STAT {LOC|REM|RWL}
Where:
•
•
•
To query to remote mode:
SYST:REM:STAT?

Enable Output

To enable or disable the output:
OUTP {ON|OFF}
To query the state of the output enable:
OUTP?
4–26
LOC: go to local mode operation
REM: go to remote mode operation
RWL: remote with local lockout. Go to remote mode operation with local
mode locked out. With RWL set, the user cannot return to local mode via the
front panel.
TM-XDOP-01XN