Connect Devices; Connecting A Conductor To The Cage Clamp; Figure 11: Connecting A Conductor To A Cage Clamp - WAGO 750-652/040-000 Manual

48

Connect Devices

7 Connect Devices
Use shielded signal lines!
Only use shielded signal lines for analog signals and I/O modules which are
equipped with shield clamps. Only then can you ensure that the accuracy and
interference immunity specified for the respective I/O module can be achieved
even in the presence of interference acting on the signal cable.
For further information about shielding, see system manual WAGO-I/O-SYSTEM
750 XTR, section "Connect Devices" > ... > "Shielding."
7.1

Connecting a Conductor to the CAGE CLAMP

The WAGO CAGE CLAMP
stranded conductors.
Only connect one conductor to each CAGE CLAMP
Only one conductor may be connected to each CAGE CLAMP
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-through
terminals.
1. For opening the CAGE CLAMP
above the connection.
2. Insert the conductor into the corresponding connection opening.
3. For closing the CAGE CLAMP
now clamped firmly in place.

Figure 11: Connecting a Conductor to a CAGE CLAMP

Manual
Version 1.3.0
750-652/040-000 Serial Interface RS-232/RS-485 XTR
®
connection is appropriate for solid, stranded and finely
®
insert the actuating tool into the opening
®
simply remove the tool. The conductor is
®
WAGO-I/O-SYSTEM 750 XTR
®
®
!
®
.